In-Home Alarm Systems
      Back to home
      1. Help Centre
      2. In-Home Alarm Systems

      Programming Transmitters and Other Accessories to the SmartHome LGX

      Any transmitters, accessories or other devices that are supplied with your LGX will already be programmed to the unit. Should you decide to add additional devices in future, they can easily be programmed to your LGX.

      Devices are programmed to your LGX using the button on the back of the unit. The LGX supports RF, ZigBee, and Bluetooth devices (optional).

      Device Learning

      • Under idle mode (backlight around the Help button is blue), press and hold the Learn button on the LGX (see below) for 3 seconds. The LGX will emit a beep when button is pressed and a second beep at 3 seconds. Release the button when the second beep is heard.
      • The LGX will enter learning mode and the HELP button’s backlight will turn purple and begin to flash.
      • Press the button on the device you are pairing to transmit a code to the LGX. If learning is successful, the LGX will beep to indicate this.
      • After finished learning all devices, press and hold the Learn button for 3 seconds again to exit Learning Mode. (The LGX will exit Learning Mode automatically after 5 minutes of inactivity.)
      • To delete a device, you must clear all programmed devices by holding the learn button for 10 seconds. Then follow the steps above to relearn the devices you wish to keep.

      LGX-Parts-Side-View

      Walk Test (Range Test)

      After all devices are learned, use the Walk Test function to test the device signal range. This is especially important prior to mounting or installing devices (e.g. call points or PIR
      beams).

      • Under idle mode (backlight around the Help button is blue), press and hold the Learn button on the LGX (see above) for 3 seconds. The LGX will emit a beep when button is pressed and a second beep at 3 seconds. Release the button when the second beep is heard.
      • The LGX will enter learning mode and the HELP button’s backlight will turn purple and begin to flash.
      • Move the device to different locations in the home and press the test button to activate it. If the LGX responds with a beep, it means the device is within the operational range.
      • Press and hold the Learn button for 3 seconds again to exit Learning Mode. (The LGX will exit Learning Mode automatically after 5 minutes of inactivity.)
      Should you require further assistance, call 1800 636 226, or email us.